This is the full factory repair manual for the New Holland T8.275, T8.300, T8.330, T8.360 and T8.390 tractors, the high-horsepower row-crop models, the same service information a dealer technician works from. It covers the whole tractor: the engine and front power take-off, the transmission, driveline and rear power take-off, the axles, brakes and steering, the primary and remote hydraulic systems, the electrical, electronic and pneumatic systems with the wiring diagrams, the cab and frame and the three-point hitch and working tools. Every section carries the specifications and capacities, the tightening torques, the functional adjustments, the fault finding and the step-by-step removal, overhaul and installation procedures, so you can chase a hydraulic, transmission or electronic problem and put it right instead of guessing.
Complete the set for your New Holland T8.275 T8.300 T8.330 T8.360 T8.390
What's Inside This Repair Manual
| System | Pages | Key Topics |
|---|
| Introduction, Specifications and Special Tools | | General Service Instructions, Safety Precautions, Torque and Capacity Specifications, Special Tools, Consumables, Model Coverage T8.275 T8.300 T8.330 T8.360 T8.390 |
| Engine and Front PTO | | Diesel Engine Description and Operation, Cylinder Head and Block, Cooling and Lubrication, Fuel and Injection, Air Intake and Exhaust Aftertreatment, Front Power Take-Off, Fault Diagnosis, Overhaul |
| Transmission, Driveline and Rear PTO | | Powershift Transmission, Ranges and Clutches, Driveline and Propeller Shafts, Four-Wheel Drive, Rear Power Take-Off, Description and Operation, Fault Diagnosis, Overhaul |
| Axles, Brakes and Steering | | Front and Rear Axles, Differential and Final Drives, Service and Parking Brakes, Hydrostatic Steering, Wheels and Tyres, Description, Fault Diagnosis, Overhaul |
| Primary Hydraulic Power System | | Pressure and Flow Compensated (Pfc) Hydraulic Pump, Standard and High-Flow Pump Options, Primary Power, Charge and Lubrication Circuits, Pressure and Flow Testing, Fault Diagnosis, Overhaul |
| Remote Valves and Three-Point Hitch | | Rear and Mid-Mount Remote Control Valves, Power Beyond, Rear Three-Point Hitch, Draft and Position Control, Hitch Calibration, Working-Tool Circuits, Fault Diagnosis |
| Electrical, Electronic and Pneumatic Systems | | Wiring Diagrams, Starting and Charging Systems, Battery, Control Modules and CAN Bus, Sensors and Actuators, Lighting and Instrumentation, Pneumatic Trailer Brake, Fault Diagnosis |
| Cab, Frame and Working Tools | | Operator Cab and Controls, Heating, Ventilation and Air Conditioning, Chassis Frame and Ballast, Front Linkage and Working-Tool Mounting, Removal and Installation |
Quick Reference Specifications
| Specification | Value | Page |
|---|
| Transmission and Hydraulic Oil Capacity | 172 liter (45 US gal) | |
| Standard PFC Pump Maximum Flow | 177 liter/min (46.5 US gpm) at rated speed | |
| Optional High-Flow PFC Pump Maximum Flow | 239 liter/min (63 US gpm) at rated speed | |
| Configuration | High-horsepower row-crop tractor | |
| Model Coverage | T8.275, T8.300, T8.330, T8.360, T8.390 | |
