Part of the New Holland Operator Manuals.
From cold-start procedure to 1200-hour fluid changes, this 150-page New Holland Workmaster 65 and 75 operator manual PDF (OEM ID 47412148) walks both tractors end to end: controls, PTO operation, three-point linkage, transport, and storage. Maintenance takes up the largest share of the book, laid out by service hour: daily checks, then 50, 300, 600, and 1200-hour jobs, each with its fluid and filter called out. Symptom tables cover engine, hydraulic lift, service brake, and electrical faults in plain language, and the ballasting section shows you wheel spacing, liquid ballast, and tire pressures for the load you're pulling. When you mount an implement, hold 100 mm (4 in) of clearance at full lift; when a wheel goes back on, the front disc-to-hub bolts take 329 N·m (243 lb ft) on 2WD models. Buy it once, keep it for the life of the tractor, with bookmarks and a live text layer for finding a spec between passes.
What's Inside This New Holland WORKMASTER 65, WORKMASTER 75 Operator Manual
| System | Pages | Key Topics |
|---|---|---|
| General Information | 7-12 | Product Overview, Fueling the Tractor, Biodiesel Fuel, Fuel Storage, Filling the Fuel Tank, Engine Access |
| Safety Information | 13-42 | Signal Word Definitions, Safety Rules, California Proposition 65 Warning, Safety Features, Safety Decals, Instructional Decals, International Symbols, Ecology and the Environment |
| Controls/Instruments | 43-56 | Operator's Seat (Operator Presence System, Roll Over Protective Structure Frame - Dynamic Description, Roll Over Protective Structure Frame - Position, Seat Belt) |
| Operating Instructions | 57-62 | Starting the Unit (Starting the Tractor, Engine Starting System - Start Warm Weather or When the Engine Is Hot, Starting a Cold Engine, Grid Heater - Start, Starting the Tractor with Jumper Cables, Stopping the Engine) |
| Transport Operations | 63-66 | Road Transport (Towing), Shipping Transport (Carrying the Tractor on a Transporter), Recovery Transport (Brakes and Controls - Tow) |
| Working Operations | 67-92 | One-Speed Rear Power Take-Off (Power Take-Off Connection, Power Take-Off Operation) |
| Maintenance | 93-132 | Maintenance Chart, Every 10 Hours of Operation or Daily (Engine Oil Level - Check, Radiator - Check, Steering Fluid Level - Check) |
| Troubleshooting | 133-134 | Symptom (Engine - Troubleshooting, Hydraulic Systems - Troubleshooting, Hydraulic Lift - Troubleshooting, Hydraulic Service Brakes - Troubleshooting, Electrical System - Troubleshooting) |
| Specifications | 135-142 | Overview, Weight, Engine - General Specification, Consumables |
| Forms and Declarations | 143-150 | Delivery Report - Owner Copy, Delivery Report - Dealer Copy |
Quick Reference Specifications
| Specification | Value | Page |
|---|---|---|
| All Models | ||
| Minimum clearance between implement and nearest part of tractor when fully raised | 100 mm (4 in) | p. 71 |
| Minimum thread engagement for lift rod tube | 40 mm (1.6 in) | p. 72 |
| Rear disc to hub bolts | 260 N·m (191.8 lb ft) ± 13 N·m (9.6 lb ft) | p. 103 |
| Rear disc to rim nuts | 239 N·m (176.3 lb ft) ± 39 N·m (28.8 lb ft) | p. 103 |
| Rear wheel weight to disc | 150 N·m (111 lb ft) | p. 103 |
| Force at end of PTO lever | 174 N (39 lb) | p. 115 |
| Battery | 12 V - 800 A cold cranking amps BCI Group-31 | p. 137 |
| Fuse ratings (1-8) | 1: 15 A · 2: 15 A · 3: 15 A · 4: 20 A · 5: 20 A · 6: 15 A · 7: 15 A (spare) · 8: 20 A (spare) | p. 127 |
| Engine oil capacity (filter included) | 8.5 L (9.0 US qt) | p. 111 |
| Transmission oil capacity | 29 L (7.7 US gal) | p. 120 |
| Final drive oil capacity | 5.6 L (6.0 US qt) | p. 121 |
| Coolant system capacity | 13.7 L (3.6 US gal) | p. 122 |
| Steering reservoir capacity | 2 L (2.1 US qt) | p. 123 |
| Valve clearance (cold) | Intake: 0.20 mm (0.008 in) · Exhaust: 0.45 mm (0.018 in) | p. 116 |
| Fuel tank capacity | 62 L (16.4 US gal) | p. 97 |
| by drivetrain (2WD/FWD) | ||
| Front disc to hub bolts | 2WD: 329 N·m (243 lb ft) · FWD: 260 N·m (191.8 lb ft) | p. 103 |
| FWD (4WD) only | ||
| Differential oil capacity | 5.5 L (5.8 US qt) | p. 123 |
| Axle hub oil capacity | 1.2 L (1.3 US qt) | p. 124 |
New Holland WORKMASTER 65, WORKMASTER 75 Common Problems This Manual Covers
New Holland Workmaster 65 won't crank, just clicks, then starts fine the next try
Check the battery terminals for corrosion and verify the battery meets the 12 V, 800 cold cranking amp spec on page 137. Sit square on the seat, clutch to the floor, shuttle in neutral; the operator presence system blocks cranking otherwise. A single click with no crank that clears on the next try is the classic sign of a loose or corroded connection (page 134 Electrical system - Troubleshooting); test the 15 A and 20 A fuses shown on page 127 before condemning the starter.
Manual Section: Electrical system p. 137PTO shaft keeps turning after shutting the lever off, mower blades won't stop
Check that the PTO lever moves through its full disengage stroke; it should take about 174 N (39 lb) at the lever end per page 115. Shut the engine down and let the implement coast before working near the shaft. Clean and grease the linkage pivots; if the clutch still drags after adjusting the jam nut and cable per page 115, have your dealer check it.
Manual Section: Working Operations p. 115Three-point hitch drops slowly, shudders, or hangs up with an implement attached
Check the transmission oil level first; the lift runs off the 29 L transmission sump shown on page 120, and low oil makes it shudder. Slow the drop with the rate control, then verify the lift rod tube keeps at least 40 mm (1.6 in) of thread engaged per page 72. Free rusty linkage pins before hooking up again.
Manual Section: Hydraulic Lift p. 72Engine slow to fire in cold weather
Below 10 °C (50 °F) the grid heater engages automatically: turn the key to RUN and wait for the grid heater indicator light to go out before turning to START; don't crank longer than 15 s, pause 30 s between tries (page 60). In sustained extreme cold, NEW HOLLAND allows SAE 5W30 engine oil per the viscosity chart on page 140 instead of the standard 15W-40. Keep the 62 L fuel tank topped up to cut condensation and drain the water trap daily.
Manual Section: Grid heater - Start p. 60Hydraulic oil overheats and remote hydraulics get sluggish partway through the afternoon
Check the troubleshooting chart on page 133; a remote lever held over relief or a plugged filter heats oil fast. Verify the levers return to neutral after each cycle, confirm the transmission sump holds its full 29 L, and clean chaff off the housing so it sheds heat. Service the hydraulic oil filter every 300 hours per the maintenance chart on page 99.
Manual Section: Hydraulic systems p. 133Frequently Asked Questions
What is the torque specification for the front disc to hub bolts on a New Holland WORKMASTER 65 or 75?
The torque specification for the front disc to hub bolts on the 2WD model is 329 N·m (243 lb ft), and for the FWD model, it is 260 N·m (191.8 lb ft). p. 103
What are the correct valve clearance specifications for the New Holland WORKMASTER 65 and 75 engine?
The correct valve clearance for the intake is 0.20 mm (0.008 in) and for the exhaust is 0.45 mm (0.018 in) when the engine is cold. p. 116
What is the engine oil capacity for the WORKMASTER 65 and 75?
The engine oil capacity, including the filter, is 8.5 liters (9.0 US quarts). p. 111
What is the transmission oil capacity for the New Holland WORKMASTER 65 and 75?
The transmission oil capacity is 29 liters (7.7 US gallons). p. 120
What is the required force to fully engage the PTO lever?
The proper amount of force required at the end of the PTO lever is 174 N (39 lb). p. 115
Will this New Holland Workmaster 65 Operator Manual download right away?
You get a 150-page searchable PDF that downloads instantly after checkout. Open it on your laptop, tablet, or phone, and bring it right to the shop floor.
Can I print a copy of this New Holland Workmaster 65 manual for the shop?
Printing is allowed without restriction. Pull the pages you need for the job and bin them when they get greasy.
Reviews
There are no reviews yet.