Part of the New Holland Operator Manuals.
Hay is down, the implement is hitched, and something on the tractor is not right: that is the moment the New Holland T3.60F, T3.70F, T3.80F operator manual PDF earns its keep, 246 pages of factory operating and maintenance instruction under OEM part number 51560220. Service intervals run from the daily engine oil check through the 50, 300, 600, and 1200 hour schedules, with a maintenance chart that lays out the whole plan. Fault code tables walk engine, electrical, hydraulic, and three-point hitch symptoms back to causes, while the working operations chapter covers PTO speeds, remote valves, and ballasting weights. Set clutch pedal free play at 35 to 40 mm, then torque your 4WD hub disk nuts to 220 N·m before heavy drawbar work. An hour from the dealer, there is nobody to ask. Searchable text and bookmarks put this PDF in the cab with you, wherever the season's work takes the tractor.
What's Inside This New Holland T3.60F, T3.70F, T3.80F Operator Manual
| System | Pages | Key Topics |
|---|---|---|
| General Information | 9-22 | Note to the Owner, Advice, Abbreviation, Product Identification, Foreword, International Symbols, Noise Level |
| Safety Information | 23-60 | Personal Safety, Foreword, Safety Rules, Warning Indicators, Alarms, And Instruments - Safety Rules, Frame - Safety Rules, Note to the Owner |
| Controls and Instruments | 61-100 | Operator's Seat (Pneumatically-Adjusted Operator Seat - Adjust, Seat Restraints - Adjust) |
| Operating Instructions | 101-106 | Starting the Unit (Engine - Operating, Start-Up - Product Identification Battery Circuit Breaker), Stopping the Unit (Brakes and Controls - Operating, Engine - Operating) |
| Transport Operations | 107-108 | Preparing for Road Transport (Brakes and Controls - Secure), Recovery Transport (Brakes and Controls - Tow) |
| Working Operations | 109-150 | One-Speed Rear Power Take-Off (Safety Rules, Turbocharger - Product Overview, Power Take-Off - Personal Safety, Power Take-Off - Operating, Power Take-Off - General Specification) |
| Maintenance | 151-206 | Maintenance Planning (Maintenance Chart) |
| Troubleshooting | 207-220 | Fault Code Resolution (Frame - Troubleshooting Engine, Electrical System - Troubleshooting, Hydraulic Systems - Troubleshooting, Rear Three-Point Hitch - Troubleshooting, Hydraulic Service Brakes - Troubleshooting) |
| Specifications | 221-228 | Frame - Dimension, Frames and Ballasting - Weight Kg, Wheels - General Specification, Electrical Systems - General Specification |
| Accessories | 229-238 | Beacon - Localization Overview, Drawbars and Towing Hitches - Operating, Hitches, Drawbars, And Implement Couplings - General Specification |
| Forms and Declarations | 239-246 | Service Record 1st 50 Hour, Owner Copy, Dealer’s Copy |
Quick Reference Specifications
| Specification | Value | Page |
|---|---|---|
| Battery Capacity | 100 Ah | p. 5 |
| Kick-out feature factory adjusted pressure | 120(+10/-0) bar | p. 131 |
| Clutch pedal distance | 35 – 40 mm (1.4 – 1.6 in) | p. 162 |
| 4WD front wheels - Hub disk nuts | 220 N·m | p. 171 |
| 4WD front wheels - Rim disk nuts | 216 N·m | p. 171 |
| Fuel filter tightening torque | 15 N·m | p. 177 |
| Air cleaner compressed air pressure | less than 2 bar | p. 174 |
| Transmission and hydraulic lift oil filter tightening | 3/4 of a turn | p. 184 |
| Hydraulic lift pressure relief valve calibration | 186 – 191 bar (2702 – 2774 psi) | p. 225 |
| Fuel Tank Capacity | 50 L | p. 152 |
| Engine Oil Capacity (with filter) | 8.5 L | p. 156 |
| Cooling System Capacity | 15.6 L | p. 156 |
New Holland T3.60F, T3.70F, T3.80F Common Problems This Manual Covers
New Holland T3.60F engine cranks but will not start on cold mornings, no warning lights showing
Check fuel level and quality first; condensation in the 50 L tank causes cold no-starts. Work through the engine no-start chart on page 207, then drain and replace the fuel filter, tightening the new element to 15 N·m as shown on page 177. Load-test the 100 A·h battery and clean both terminals before blaming injection.
Manual Section: Engine Troubleshooting p. 207Engine coolant temperature warning comes on under heavy draft load, steam from the radiator cap
Check coolant level once the engine cools; the system holds 15.6 L per page 156, and a slow leak will empty it mid-season. Clean chaff and dust out of the radiator and grille screens with the fan stopped, then work the overheating steps on page 207 if the temperature light returns under load.
Manual Section: Engine Troubleshooting p. 207Three-point hitch will not raise a mounted implement, lift arms creep down slowly at idle
Check transmission oil level first; the rear transmission shares its 32.5 L fill listed on page 156 with the hydraulic lift, and a low level explains most weak hitches. Verify the implement weighs less than the 2277 kg lift capacity at the link ends on page 224, then work through the three-point hitch troubleshooting table for linkage and lowering faults.
Manual Section: Rear Three-Point Hitch TroubleshootingHydraulics slow and noisy once the oil warms up, remote valves respond late
Check the transmission and hydraulic oil level with all cylinders retracted before anything else; low oil makes the pump whine when warm. Replace the transmission and hydraulic lift oil filter if it is due, tightening the new cartridge 3/4 of a turn after gasket contact per page 184, then recheck response with the oil at working temperature.
Manual Section: Hydraulic Systems TroubleshootingBrake pedals feel soft and sink close to the floor before the tractor slows
Measure service brake pedal travel; it should stay between 50 and 55 mm per page 163, with 5 mm of free play. Adjust pedals that travel farther, then check the brake circuit reservoir; the circuit only holds 0.46 L, so any leak shows fast. Work the soft pedal checks in the brake troubleshooting section if travel stays long.
Manual Section: Hydraulic Service Brakes TroubleshootingFrequently Asked Questions
How do I reset the engine oil service light on a New Holland T3.60F?
To reset the engine oil service light, enter the programming menu by pressing switch (2)/(B) for more than three seconds. Navigate using switch (3)/(D) until the engine oil icon appears, then press switch (2)/(B) to reset. A check mark will appear on the screen when the process is complete. p. 92
What are the torque specifications for the front wheel hub disk nuts on a 4WD New Holland T3.60F / T3.70F / T3.80F?
The torque specification for the front wheel hub disk nuts on 4WD models is 220 N·m (22.4 kgm). p. 171
What is the correct fuel filter replacement procedure on the New Holland T3.60F / T3.70F / T3.80F?
Place a container under the filters, remove the cartridge, lightly oil the seal of the new cartridge, and screw it down into contact with the support. Tighten it by hand by 3/4 of a turn (15 N·m). p. 177
What is the fuel tank capacity of the New Holland T3.60F / T3.70F / T3.80F?
The standard fuel tank capacity is 50 L (13.2 US gal), with an optional 63 L (16.38 US gal) tank available. p. 152
What engine oil is recommended for the turbocharged New Holland T3.60F / T3.70F / T3.80F engines?
NEW HOLLAND AMBRA UNITEK 10W-40 is the recommended oil for turbocharger engines. p. 175
What exactly do I receive with this New Holland T3.60F Operator Manual?
All 246 pages arrive as one searchable PDF at checkout. Read it at the desk, then take the phone out to the machine.
Is this New Holland T3.60F Operator Manual printable?
Yes, print as many copies as you want, and there are no restrictions. Many mechanics print the section they need and bring it to the shop floor.
Reviews
There are no reviews yet.